Can You Replace the Battery in a 17" 2009 Macbook Pro

• Remove the following ten screws securing the lower case to the upper example:

• 3 13.5 mm Phillips screws.

• 7 three mm Phillips screws.

• Wedge your fingers between the lower example and the vent, and lift up to release the 2 clips holding the lower case to the upper example.

• During reassembly, carefully align the lower instance and then press it firmly until both clips engage.

• Remove the lower example.

• Whenever working most the logic board, it is always wise to first disconnect the battery to avoid short circuits.

• Catch the plastic tab attached to the battery connector and pull information technology toward the front end border of the device.

• Pull the tab parallel to the face of the logic board.

• Remove the three 6.five mm Tri-point screws securing the battery to the upper example.

• Employ a plastic opening tool or another soft sparse-edged tool to carefully lift up a corner of the "Warning: Practise not remove the battery" sticker off the right speaker/subwoofer enclosure.

• Peel the sticker off the right speaker/subwoofer enclosure.

• It is non necessary to completely peel the sticker off the bombardment.

• Elevator the battery by its attached pull tab and remove it from the upper case.

• If you're installing a new battery, you should calibrate it subsequently installation:

• Charge it to 100%, and so go along charging information technology for at least two more hours. Next, unplug and use it normally to bleed the bombardment. When you see the low bombardment warning, salvage your piece of work, and go on your laptop on until it goes to sleep due to depression bombardment. Wait at least 5 hours, then accuse your laptop uninterrupted to 100%.

• If yous discover any unusual behavior or problems after installing your new battery, yous may demand to reset your MacBook's SMC.

traviswhory1987.blogspot.com

Source: https://www.ifixit.com/Guide/MacBook+Pro+17-Inch+Unibody+Battery+Replacement/3403

Share this post